Eastwood Rust Encapsulator has been tested by an independent lab to be one of the most effective rust-preventive products yet. Rust Encapsulator is a great primer for floor pans and other underbody parts. It fills tiny pin-holes and surface irregularities, and is compatible with lacquer, enamel and urethane topcoats (including Eastwood Chassis Black). For the absolute ultimate rust remedy, first brush or spray-on Eastwood Rust Converter, then prime with Rust Encapsulator. One 425g aerosol covers about 10 sq. ft., and contains no isocyanates. Heat-resistant up to 204°C. Made in the USA.
Use a wire brush to remove loose rust, scale and paint, and remove dust, grease and oil deposits. Wipe down with Pre Painting Prep. Feather surrounding paint with 220-grit sandpaper. Shake can for at least 2 minutes once the mixing ball starts to rattle. Hold the Rust Encapsulator can 25-30" above surface as you spray. A single coat dries to the touch in 20 minutes, and is thoroughly dry in 3-4 hours at 20°C. For greater durability, a second coat can be applied 1 hour after the first. Allow 6-8 hours after the last coat before applying topcoat. Use over or under body fillers.
Work in a well-ventilated area when applying this product. The use of a respirator is recommended. Shake aerosol vigorously for 2 minutes before spraying.
|Unit Of Measure||each|