Super strong magnets hold patch panels in place from the outside, perfect for blind repairs.
8 pack of strong rare earth magnets
1/2 inch (12.7mm) diameter disc
Strong enough to hold patch panels
Hold flush patches in perfect alignment
Position panels with no gaps
Perfect for blind repairs
If you have ever tried to weld a patch panel into a spot where you can’t access the back side, these rare earth magnets are a life saver. These nickel plated super strong magnets come 8 to a package, and each one measures just 1/2 inch (12.7mm) in diameter, but are strong enough to support several pounds. Place them every few inches at the edge of your panels and you can position the panel with no gap, or the perfect gap for whichever welding method you are using. Use a few of these magnets and never feel like you need 3 hands again.
These 12.7mm diameter x 19mm length rare earth neodymium nickel plated magnets are design to offer superior panel alignment when welding patch panels. With N35 strength, high heat resistant of up to 200F, these magnets will keep both panels in perfect alignment when stitch welding. 8 pieces are included in this kit in which are used approximately 2 inches apart along your weld seem. The magnets will keep both panels level and aligned, while eliminating panel gaps, distortion and raised/recessed areas. For use when MIG, TIG or Gas welding to hold panels while tack welding material.
12.7mm diamter x 19mm length, 8 N35 strength Neodymium rare earth magnets
Magnets are nickle plated to eliminate corrosion. In use the nickle plate may chip and the magnets may need to be replaced after time.