Lead Sticks 5 Pack (Thin Sticks) approx 1kg

Lead Stick 5 Pack 200 grams/per stick +-

These thin lead sticks require less heat. They allow precise control around edges and smaller panels where the heat saturation occurs quicker, perfect for edges and corners.

Heat saturation of the panel is when the panel is hot enough to “accept” the lead, some warming of the lead stick in hand is always required but the majority of the heat has to come from the panel to ensure correct application.

Made in Australia from new material, pure materials. Resulting in less poristy and more controllable soft tempature range, unlike lead sticks made from recycled materials. 

Traditional lead has been used by early auto manufacturers to cover body joins and seams. At the time this was the only material available for the job. It has been regarded as the best method to do so, and in most cases has lasted the test of time. Later in the 1950's lead was heavily used by the pioneers of car customisation and hence the term "lead sled" was then derived. When it comes time to restore a vehicle, lead has its place for an authentic project.

Lead is a filling material for areas on a vehicle that require it. Most commonly used on sections that cannot be metal repaired completely. It is perfect on pillars, panel edges, exterior corners and shut lines. Its strength is also ideal for door and panel edges that are vulnerable for chipping. Lead is perfect to cover over seams and overlapped metal; it will not show up witness lines or shrink in these areas.

Porosity in a sub straight has potential to bubble and blister paintwork in the future. By eliminating this, quality paintwork in ensured. Unlike other suppliers of lead, Melomotive's lead is cast from brand new materials. This process eliminates any trace of contaminants and no porosity; making this a pure, more spreadable material.

The 30% tin / 70% lead formula is ideal for its low melting point and prolonged spreadable range of 180°C to 250°C. Works well on horizontal and vertical surfaces.

SDS

Qty:

5 x 30/70 lead solder stick 200 grams (+/-50g) Total weight +- 1kg

Each stick is approximately 35cm in length

Enough lead to get started and complete a few small repairs. Ideal for corners/edges.